Note: LucasForums Archive Project
The content here was reconstructed by scraping the Wayback Machine in an effort to restore some of what was lost when LF went down. The LucasForums Archive Project claims no ownership over the content or assets that were archived on archive.org.

This project is meant for research purposes only.

Video Card/Brightness problem

Page: 1 of 1
 HellFyre69
02-19-2004, 1:26 AM
#1
I previously owned a Geforce4 4200, and I had my brightness set up about in the middle.

Now i Recently bought a Radeon 9700 Pro, and it seems that my brightness goes back to normal, everytime i start up the game. pls is getting annoying, Help!

BTW: Im using the latest video card drivers, and settings @ 1024* 800 32 bit Everything on hightest, Trilianer.
 shukrallah
02-19-2004, 1:43 AM
#2
hmmm... you might have to set it yourself, through the console.

try these commands in game:



r_intensity "1.8" - This command increases the brightness of texture colors. With a low r_OverBrightBits, you may have to boost this to around 2 (default is 1). Keep experimenting until you find a brightness level you are comfortable with.

r_gamma "2" - This is the master command that adjusts the brightness level of everything in the entire game. All splash screens and menus, along with the actual game play is affected. The default value is 1, but you should usually make this higher, depending on the brightness of your monitor (and to compensate for a low r_OverBrightBits setting). Try 1.4, 1.6, 1.8, 2 etc until you find a good setting. When setting r_OverBrightBits to 0, you'll have to juggle around between r_intensity and r_gamma until you find something you are comfortable with.


thats a quote from this: Team Image Config Guide (http://www.team-image.net/files/configguide.html)
 HellFyre69
02-19-2004, 7:00 AM
#3
Well i tried that, and i did not work. Everytime i quit JKA, and run it again, it goes the brightness/gamma goes back to default. However if i move the bar a little bit, it turns back into normal. =\

weird...
 Crow_Nest
02-19-2004, 7:39 AM
#4
Try adding that command to your config file in base.

Btw, thx for that link :)
 HellFyre69
02-19-2004, 5:24 PM
#5
Is already set up on my config. I Think this is a problem related to my videocard or something...

Anyone has the same problem? This only happen on JKA.
 Crow_Nest
02-20-2004, 4:52 AM
#6
Do you have the patch installed?
 HellFyre69
02-22-2004, 1:13 AM
#7
yes, i have the last patch

1.01
 Crow_Nest
02-22-2004, 10:31 AM
#8
Do you have the latest ATI drivers? Cat4.1, you can get it from the ATI site.
 HellFyre69
02-24-2004, 11:35 PM
#9
Yes, I have the latest ones, and it is actually.. Cat4.2
 Crow_Nest
02-25-2004, 12:04 PM
#10
Originally posted by HellFyre69
Yes, I have the latest ones, and it is actually.. Cat4.2

Then try the old drivers again, like cat3.9 or 3.8
Page: 1 of 1