Note: LucasForums Archive Project
The content here was reconstructed by scraping the Wayback Machine in an effort to restore some of what was lost when LF went down. The LucasForums Archive Project claims no ownership over the content or assets that were archived on archive.org.

This project is meant for research purposes only.

Could not find <mapname>.prt

Page: 1 of 1
 HiryuSwift
08-16-2003, 8:44 PM
#1
Whenever I try to make my map into a .bsp, during the Vis process it comes up with "Could not load <filepath>/<mapname>.prt" and it stops creating the .bsp file, any ideas?

I'm using Jk2 radiant
 Leslie Judge
08-16-2003, 9:21 PM
#2
If there is no .prt file then you probably have a leak. You have to have red lines in your map after compiling. If you can't see them, then try to load the Pointfile from the File menu, and check out junk.txt in your TEMP folder.
 HiryuSwift
08-16-2003, 9:38 PM
#3
There's no red lines, File>Pointfile... doesn't do ANYTHING, and there's nothing in Windows/Temp/junk.txt :p
Page: 1 of 1